The most important?consideration in the design and implementation of a bulk material vessel is the material itself. Every material has different properties of cohesion that are considered and a solution applied that allows for the best flow possible. We get it right the first time, saving you time, money, and aspirin.
A poorly-designed hopper?can cause a lot of problems and headaches that no one has the?time to deal with. Through scientific evaluation and best-practice design principles we will get it right the first time – ensuring that your material flows as it should so you can move on to more pressing concerns.
The system above?consists of?a use-bin, airlock, and bin vent. Our blower is located outside and powers the system. Our client dumps supersacks of sugar into the top. The sugar is metered out by the airlock. A negative pressure fan sucks air up through the dust filter. The sugar is then pneumatically conveyed to a mechanical separator where it is sifted for large items, and then sent to trucks.
Funnel Flow vs. Mass Flow
Two important concepts in bin design?is Funnel Flow and Mass Flow.
In funnel flow, material flows downward by gravity in the middle of the bin?with stagnant material remaining along the wall of the vessel. Funnel flow?can be advantageous when headroom is at a premium and the application is not depending on FIFO (First-In-First-Out) sequence or uniform flow.
Funnel flow in a bin that doesn’t completely discharge can limit the capacity of the tank, as material left in the tank reduces ‘live’ capacity.?It can also segregate fines and dust, keeping your material from uniformly flowing into the next stage of your process.
In worst-case scenarios, your material will be erratic or stop altogether, and you end up with idle equipment that can cause delays in shipping your product.
In many applications funnel flow isn’t a problem, and depends on the material and process. If funnel flow produces undesirable effects?then Mass Flow may be the answer to the problem.
Mass flow may be necessary to ensure your process runs smoothly, or to ensure FIFO sequence discharge. To create mass flow (uniform flow of material), bin and cone geometry?is the first factor taken into consideration. We design mass flow hoppers to avoid bridging, rat-holing, and other problems by optimizing the ratio between material height to bin width.
Depending on the material and application we may also employ industrial-duty cone treatments such as aeration or vibration pads to keep the material flowing smoothly, and baffles. These must also be applied with great care, as misapplication of cone treatments can cause problems as well.
US Systems Solves Flow Problems:
Use?bins, surge hoppers, day bins, scale hoppers, storage bins, batch bins, tanks, vessels and silos are important but humble pieces of process equipment. They absolutely need to run reliably or an entire process line can sit idle.
We have the experience and expertise to analyze your needs, and design a safe, reliable system that avoids many of the problems we’ve seen in systems designed by others.
Our philosophy is that form follows function. The first question is, “What does this particular part of the process need to do?”. Then?we design your system around that question to create the most cost-effective, least maintenance, reliable option.
When it comes to our?storage, batching, and scaling systems, we:
- First and foremost build safe structures to prevent injury and equipment damage
- Produce reliable flow by avoiding bridging and ratholing
- Apply cone treatments to work reliably and avoiding problems
- Ensure proper ventilation where needed to avoid dust issues
- Take into consideration material build-up and bin cleaning
- Avoid condensation, that can ruin material and impede flow
- Build systems with user-friendly access points
- Eliminate dead spots with muliple outlets